Sandton Emergency Plumbing
Kitchen Plumbing
The busiest plumbing in the house deserves the most attention.
Call 010 500 1849The kitchen carries more plumbing load than any other room. Hot and cold supply, a waste line handling grease and food solids, a dishwasher inlet and drain, often a fridge water line and increasingly a filtered or boiling-water tap. Each one is a potential leak point sitting inside a cupboard where nobody looks until the chipboard swells.
We handle everything from a single mixer replacement to complete renovation plumbing set out from your kitchen designer's drawings, coordinated with the cabinetmaker so first fix and second fix land in the right sequence.
Renovation coordination
We work to the kitchen plan and to the installer's programme, so plumbing never becomes the reason the job is late.
Appliance-ready connections
Dishwashers, washing machines and fridges are connected with isolating valves and correctly fallen waste.
Grease-aware waste design
Waste runs are set out with proper fall and access, which is the single biggest factor in avoiding recurring blockages.
Cabinet protection
Leak-prone joints are positioned accessibly and sealed properly rather than buried behind a fixed panel.
How kitchen plumbing actually works
Most kitchen plumbing failures come from three places. Flexible connector hoses on mixers perish and burst, often after five to eight years, and because they sit under the sink the failure is discovered late. Dishwasher inlet connections work loose through vibration. And the waste trap and its connections, which were only ever hand-tightened during installation, drip slowly onto a cupboard base for months.
Waste line design deserves more attention than it usually gets. A kitchen waste carrying fats needs consistent fall, generous bore and a rodding point that is actually accessible. Where we inherit an existing kitchen that blocks repeatedly, the fix is frequently re-setting the waste run rather than another round of drain clearing.
On new installations and renovations we set out the first fix carefully around cabinetry: isolating valves on every appliance feed so a future repair does not mean shutting the whole house down, hot and cold arriving where the mixer actually needs them, and enough slack to service without dismantling. It is a small amount of extra thought that saves considerable money later, and it applies equally to our bathroom plumbing work.
Common issues we see
- Leaking waste trap discovered as swollen cupboard board
- Failed flexible connector hoses under the sink
- Dishwasher not draining or leaking at the inlet
- Slow-draining sink from fat build-up
- Low flow at the kitchen mixer only
- Fridge water line leaking behind the unit
- No isolating valves, meaning the whole house must be shut off
When to call us immediately
- You find damp or swelling inside the sink cupboard
- The kitchen sink drains slowly or gurgles
- You are installing a new dishwasher or washing machine
- You are renovating and need first and second fix plumbing
- You want a filtered or boiling-water tap installed
Our process
What happens after you call
- 1
Survey and plan
Existing supply, waste positions and appliance requirements are mapped against the new layout.
- 2
First fix
Supply and waste are installed and pressure-tested before cabinetry and surfaces go in.
- 3
Second fix
Sink, mixer, appliances and isolating valves are fitted and commissioned once units are in place.
- 4
Leak test and handover
Every joint is run and checked under load, and you are shown where each isolating valve is.
Frequently asked questions
Can you move my sink to a different wall?
Usually yes, though the waste run and available fall determine how far. We assess this before the kitchen design is finalised, which avoids expensive surprises.
Do you connect dishwashers and washing machines?
Yes, including fitting dedicated isolating valves and ensuring the waste connection has correct fall and an air break.
How often should flexible connector hoses be replaced?
Every five to eight years as a precaution. They are inexpensive and a burst hose under a sink can cause substantial damage.
Why does my kitchen sink keep blocking?
Almost always fat build-up, sometimes worsened by insufficient fall on the waste run. We jet the line and then check whether the pipework itself needs re-setting.
Can you work with my kitchen installer?
Regularly. We coordinate directly with cabinetmakers and contractors so first and second fix happen at the right stage.
Related services
Where we deliver this service
Sandton Emergency Plumbing
Africa's busiest business district, plumbed and protected around the clock.
Midrand Emergency Plumbing
The fastest-growing corridor in Gauteng, served by plumbers who live in it.
Randburg Emergency Plumbing
Established Johannesburg suburbs, ageing pipework, and plumbers who know both.
Centurion Emergency Plumbing
From Irene's smallholdings to Highveld's office parks, covered around the clock.
Need kitchen plumbing today?
We answer every call in person, 24 hours a day, 7 days a week — including public holidays. Emergency plumber dispatched in as little as 20 minutes.